Schafer Logo
About Schafer  Career Opportunities  Schafer Locations  GSA Schedule Contracts  Our Capabilities
Home | Contact Us  

Our Customers
 Recognition by Customers

 
 

 

 




Recognition by Customers



10 August 1998
David E. Hebron
Member of Technical Staff
Target Fabrication
Sandia National Laboratory
Albuquerque, New Mexico

Ms. Diana Schroen-Carey
Schafer Corporation


Diana,

The Dynamic Hohlraum shot that was taken on Friday, August 7, 1998 for Mark Derzon was another record shot on the Z machine. The target was a bare TPX foam cylinder 8-mm diameter x 10-mm tall with a density of about 15 mg/cc.

The shot was 12 TW and the hohlraum temperature went to 250 eV! :-)

Attached is a digital image of the foam mounted to the castle piece of the wire array hardware. The image is not very good, the foam was not smaller in the center than the ends, it was perfectly straight; it is often impossible to get top quality images on short notice. We assembled this target with just enough time to get a couple of quick images and then had to get it delivered to the wire array laboratory.

Congratulations to you and your staff. This foam target was typical of the cylinders you have been providing Sandia for the Z machine shots, and these results could not have happened without this excellent quality foam target.

Regards,
David E. Hebron
Member of Technical Staff
Target Fabrication
Sandia National Laboratory
Albuquerque, New Mexico




©2001-2004 Schafer Corporation. All rights reserved.